Catalytic converter efficiency (Bank 2)

P0430 Code: Catalyst Efficiency Below Threshold (Bank 2)

P0430 stands for "Catalyst System Efficiency Below Threshold (Bank 2)." It is the Bank 2 version of P0420. Bank 2 is the side of the engine that does not hold cylinder #1. The computer has decided the catalytic converter on that side is not cleaning the exhaust as efficiently as it should.

Like P0420, P0430 is an efficiency reading, not a direct test of the catalytic converter. The computer compares the oxygen sensors before and after the Bank 2 converter and decides it is not storing enough oxygen. Several things besides a bad converter can cause that comparison to fail — and P0430 often appears together with P0420 when the cause affects both banks.

How serious: Low to moderate

P0430 rarely leaves you stranded. The car usually drives normally with a steady light. It is not an emergency, but it should not be ignored indefinitely — it can hide other engine problems, hurt fuel economy, and will fail an emissions test.

Safe to drive? Usually yes — for a while

In most cases you can keep driving with a steady P0430 light. If the Bank 2 converter is physically clogged (sluggish acceleration, heat under the car, a strong sulfur smell), stop driving and have it checked — a blocked converter can overheat and damage the engine. A blinking light is a separate misfire and means you should pull over.

P0430 symptoms you might notice

Common causes of P0430

Bad catalytic converter on Bank 2

The Bank 2 converter’s honeycomb can melt, clog, or lose its coating. This is the most expensive cause but not the most common.

Bank 2 downstream O2 sensor reading wrong

The downstream sensor on Bank 2 can fail or respond slowly without its own code, making a healthy converter look bad.

Exhaust leak before the Bank 2 converter

A leak on the Bank 2 side lets in outside air and skews that side’s O2 sensor readings, triggering P0430 even with a good converter.

Engine misfire or rich/lean on Bank 2

Unburned fuel or a rough-running bank overloads that converter and can trip the efficiency code as a symptom of another problem.

Failing Bank 2 upstream O2 sensor

A lazy upstream sensor on Bank 2 throws off the mixture and the converter’s oxygen storage, leading to a false efficiency failure.

Damaged wiring at a Bank 2 O2 sensor

Corroded, melted, or loose wiring on the Bank 2 sensors causes erratic readings that look like converter failure.

Before you buy parts

P0430 does not automatically mean the Bank 2 catalytic converter needs replacing. The code only says the computer thinks that converter’s efficiency is low — and that reading depends on oxygen sensors, exhaust leaks, and how the engine runs. Many P0430 repairs are sensors, wiring, or exhaust leaks, not a new converter. Confirm the cause before replacing the catalytic converter.

What to check for P0430

Possible repairs for P0430

Fix a Bank 2 exhaust leak

Repairing a cracked pipe, leaking gasket, or bad flex joint ahead of the Bank 2 converter often clears P0430 without replacing the converter.

Replace a faulty Bank 2 oxygen sensor

A slow or failed Bank 2 downstream (or upstream) O2 sensor is a common and far cheaper fix than a catalytic converter.

Repair wiring or connector issues

Corroded or melted Bank 2 sensor wiring can be repaired without replacing the converter or the sensor.

Fix an underlying engine problem

Resolving a misfire, rich condition, or vacuum leak that overloaded the Bank 2 converter can restore normal efficiency readings.

Replace the Bank 2 catalytic converter

Only after leaks, sensors, wiring, and engine running are all confirmed good. Choose a CARB-compliant converter if required in your state.

Parts and tools that may help

Enter your year, make and model on the store's site to see parts that fit your car.

GarageGuide may earn a commission if you buy through these links, at no extra cost to you. Always check that a part fits your exact vehicle before buying.

P0430 frequently asked questions

Does P0430 mean my catalytic converter is bad?

Not necessarily. P0430 means the computer detected low efficiency on the Bank 2 converter, but that reading depends on oxygen sensors, exhaust leaks, and engine running. A faulty sensor or exhaust leak is a common and cheaper cause.

Can I drive with a P0430 code?

Usually yes, if the light is steady and the car drives normally. If you notice sluggish acceleration, a sulfur smell, or heat under the car, the Bank 2 converter may be clogged — have it checked. A blinking light is a separate misfire and means you should pull over.

Why do P0420 and P0430 appear together?

When both banks show low efficiency at once, the cause is often shared — an engine running problem (misfire, rich condition) or something affecting both converters — rather than two separate bad converters.

Will P0430 fail an emissions test?

In most areas, yes. An illuminated check engine light is an automatic emissions failure, even if the car runs fine.

What is the most common cause of P0430 besides the converter?

A slow or failed Bank 2 oxygen sensor and exhaust leaks ahead of that converter are both very common. Reading all the stored codes and checking for exhaust leaks should come before replacing the converter.

Related car problems

Related codes